4280005510 DENSO STARTER 12V 1.8KW 12T

Instructions for repair of nippondenso starters

tools needed: 7mm or 8mm socket depending on model, 12mm socket and 14mm deep

socket ( helps to use grinder on 14mm socket to thin edge out )

disconnect battery on vehicle and remove starter. secure starter on vise.

remove cover from solenoid and remove plunger assembly.

use 12mm socket to remove nut from Starter Motor lead to solenoid.

use 14mm socket to remove nuts from battery and motor sides of solenoid then remove

contacts, insulators and post from solenoid. then clean dirt from inside of solenoid.

solenoid contact post on the motor side is attached to the starter contact. secure

contact in vise and gently tap post to remove from contact.

install new contacts into solenoid in reverse of removal. take care to make sure that

new solenoid contacts are level when you tighten the 14mm nut. if they aren't it will

reduce the life of new contacts.

inspect solenoid plunger for wear. we recommend replacing solenoid plunger for

maximum life but, if you reuse the old plunger make sure the surface is clean. then

reinstall plunger.

reinstall solenoid cap and bench test.

install on vehicle and you're ready to roll

SPECIFICATION:

Other items we deal with:
AUTO STARTER, Car Alternator, Starter motor parts, Alternator Parts, Center bearing, Water Pump , Power Steering Pump, ENGINE PARTS, CLUTCH PARTS etc.